DNN991HD/ DNN9710BT>Remote Control>Starting procedure

Starting procedure

This unit can be operated using the remote control.

#CAUTION

  • Put the remote control in a place where it will not move during braking or other operations. A dangerous situation could result, if the remote control falls down and gets wedged under the pedals while driving.
  • Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.
  • Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician.
  • Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a physician.

Battery Installation

If the remote control operates only over shorter distances or does not operate at all, it is possible that the batteries are depleted.

In such instances, replace the both batteries with new ones.

  1. 1 Insert two “AAA”/“R03”-size batteries with the ¢ and ¤ poles aligned properly, following the illustration inside the case.

Contents