DNN991HD/ DNN9710BT>Controlling Audio>Equalizer Control

Equalizer Control

You can adjust equalizer by selecting the optimized setting for each category.

  1. 1 Touch [ ] on any screen.
  2. 2 Touch [Audio].

Audio screen appears.

  1. 3 Touch [Equalizer].

Equalizer screen appears.

Controlling EQ curves

  1. 1 Select EQ curve from [Natural], [Rock], [Pops], [Easy], [Top40], [Jazz], [Powerful], [iPod], and [User].

NOTE

  • [iPod] is available only during iPod source.

Controlling equalizer manually

The Graphic Equalizer cannot be set when you select [iPod] in the Equalizer screen.

  1. 1 Touch [EQ] in the Equalizer screen.
  2. 2 Touch the screen and set the Graphic Equalizer as desired.

Gain level (light green boxed area)

Adjust the gain level by touching the each frequency bar.

Touching [C], [D], [R] and [S] can also adjust the level. Use [C] and [D] to select a frequency, and [R] and [S] to set the level.

EQ INIT

Returns to the previous level which the gain level is adjusted.

Flat

Tone curve becomes flat.

Bass EXT (Bass Extend Settings)

When turned on, the frequency lower than 62.5 Hz is set to the same gain level as 62.5 Hz.

Loudness

Set the amounts of boost of low and high tones. “OFF”, “Low”, “High”

SW Level

Adjust the subwoofer volume. This setting is not available when subwoofer is set to “None”. See Speaker setup.

Contents