DPX500BT/DPX300U>13. General settings>13-4. Initial settings

13-4. Initial settings

You can configure initial settings of this unit.

  1. Select the Standby source.

    Refer to <Source selection>.

  2. Press and hold the [AUDIO] button.

    Enter the Function setting mode.

  3. Use the [Control knob] to select "INITIAL SET".

    For how to use the [Control knob], refer to <3-3. How to select the item>.

  4. Use the [Control knob] to select an Initial setting item.

    Display

    Description

    "PRESET TYPE"

    Sets the Tuner preset type.

    "TYPE NORMAL": 1 station can be assigned to 1 preset button in each of 4 bands (FM1, FM2, FM3, and AM), i.e., a total of 24 stations (6 stations x 4 bands) can be preset.

    "TYPE MIX": A total of 6 stations can be assigned to a total of 6 preset buttons regardless of band (FM1, FM2, FM3, and AM). You can recall a preset station without switching between bands.

    "KEY BEEP"

    Setting the operation check sound (beep sound) ON/OFF.

    "ON" / "OFF"

    "PANDORA SRC"

    Sets whether to display Pandora during source selection.

    "ON" / "OFF"

    "IHEART SRC"

    Sets whether to display iHeartRadio during source selection.

    "ON" / "OFF"

    (Function of DPX500BT)

    "AHA SRC"

    Sets whether to display aha during source selection.

    "ON" / "OFF"

    (Function of DPX500BT)

    "BUILT-IN AUX"

    Sets whether to display AUX during source selection.

    "ON" / "OFF"

    "CD READ"

    Sets the method for reading CD.

    When unable to play a special format CD, set this setting to "2" to force playing. Note that some music CDs may be unplayable even when set to "2".

    In addition, audio files cannot be played when set to "2". Normally, keep this set to "1".

    1: Automatically distinguishes between the audio file disc and music CD when playing a disc.

    2: Forces playing as a music CD.

    "SP SELECT"

    Sets the speaker type so that the System Q value is optimal.

    "OFF": OFF

    "5/4": For 5 & 4 in. speaker

    "6*9/6": For 6 & 6x9 in. speaker

    "OEM": For the OEM speaker

    "F/W UPDATE"

    Upgrades the firmware.

    When the firmware version appears, press [Control knob].

    Selecting "YES" and then pressing the [Control knob] starts upgrading the firmware.

    For how to update the firmware, access our web site.

    http://www.kenwood.com/cs/ce/

    (Colored text: Factory setting)

  5. Use the [Control knob] to select a setting.

    The previous item appears.

Exit the Function setting mode.

Press and hold the [6] button.

Contents