15-5. Bluetooth detail setting
You can configure the initial settings of this unit.
- Press the [Ú] button.
"BT MODE" appears and enter the Bluetooth mode.
- Use the [Control knob] to select "SETTINGS" > "DETAILED SET".
For how to use the [Control knob], refer to <3-3. How to select the item>.
- Use the [Control knob] to select an Bluetooth detail setting item.
Display
Description
"AUTO ANSWER"
Automatically answers a call after lapse of the preset time interval.
"OFF": Does not answer the phone call automatically.
"1" – "8" – "99":
Automatically answers the phone call after lapse of 1 – 99 seconds.
"RECONNECT"
When set to "ON", starts re-pairing with the registered Bluetooth device automatically when it becomes unpaired.
"ON" / "OFF"
When set to "ON", performs Bluetooth pairing automatically when the iPhone is connected to the USB terminal.
"ON" / "OFF"
"BT HF/AUDIO"
Specifies the output speakers for hands-free voice communication and Bluetooth audio sound.
"FRONT" : Outputs sound from the front speakers.
"ALL" : Outputs sound from the front and rear speakers.
"CALL BEEP"
Sets whether to output a beep from the speaker when a call comes in.
"ON" : Outputs a beep.
"OFF" : Does not output a beep.
"MIC GAIN"
Adjusts the sensitivity of the microphone for telephone call or adjusts the voice of the caller.
"-20" – "0" – "+8"
"ECHO CANCEL"
Sets the echo cancellation level.
"1" – "4" – "10"
(Colored text: Factory setting)
- Use the [Control knob] to select a setting.
The previous item appears.
Exit the Bluetooth mode.
Press the [Ú] button.
