DNN9350BT/ DNN9350BTM/ DNR8035BT/ DNR8035BTM>Setting Up>Display Setup

Display Setup

  1. 1 Touch [ ] on any screen.
  2. 2 Touch [SETUP].

SETUP Menu screen appears.

  1. 3 Touch [Display].

Display screen appears.

See the following section for each setting.

Monitor angle control

You can adjust the angle of the monitor.

  1. 1 Touch [Angle] in the Display Menu screen.

Angle setup screen appears.

  1. 2 Select a number below an angle that will best suit your monitor viewing.

Default is “0”.

NOTE

  • You can store the current monitor angle as the angle during power off. Touch [Memory] when the desired angle is selected.

Panel color coordinate

You can set the button illumination color.

The selectable items differ depending on the unit.

  1. 1 Touch [Color] in the Display Menu screen.

Color screen appears.

  1. 2 Touch [SET] of [Panel Color Coordinate].

Panel Color Coordinate screen appears.

NOTE

  • You can touch [SET] or [Initialize] when [Panel Color Scan] is set to off.
  • Touch [Initialize] to reset the settings to the default settings.

  1. 3 Touch the desired color.

Registering original color

You can register your original color.

  1. 1 Touch [Adjust] in the Panel Color Coordinate screen.

Panel Color RGB Coordinate screen appears.

  1. 2 Use [C] and [D] to adjust each color value.

  1. 3 Touch the desired preset key for 2 seconds.

Panel color scan

You can set the panel color to continuously scan through the color spectrum.

  1. 1 Touch [ON] of [Panel Color Scan] in the Color screen.

Panel Color Scan is set to on.

Contents