KDC-X797/KDC-BT755HD>15. Bluetooth SETUP>15.4 Changing the Bluetooth detail settings

15.4 Changing the Bluetooth detail settings

You can change a Bluetooth detail setting item(s) according to your listening preference.

  1. Press [ Ú ] to enter Bluetooth mode.
  2. Turn the volume knob to select SETTINGS, then press the knob.
  3. Turn the volume knob to select DETAILED SET, then press the knob.
  4. Turn the volume knob to select a desired setting item, then press the knob.
    • See table below for selection.
    • Press [ 6 ] to return to the previous item.

To cancel the Bluetooth mode

Press [ Ú ].

Display

Description

PIN CODE EDIT

For details, see <15.3 Registering the PIN code>.

AUTO ANSWER

OFF: Does not answer the phone call automatically. ; 1 – 8 –99: Automatically answers the phone call after lapse of 1 – 99 seconds.

RECONNECT

ON: Automatically reconnects the selected Bluetooth device when radio wave becomes strong enough, even after it is disconnected. ;
OFF: Not uses auto reconnect.

When this function is turned ON, the Bluetooth device is reconnected if it has been disconnected by selecting PHONE SELECT/ AUDIO SELECT.

AUTO PAIRING

ON: Automatically performs Bluetooth pairing when the iPhone or iPod touch is connected to the USB terminal. ; OFF: Not uses auto pairing.

BT HF/AUDIO

FRONT: Outputs audio from the front-left and front-right speakers. ;
ALL: Outputs audio from the all speakers.

CALL BEEP

ON: Sets whether to output a beep from the speaker when a call comes in. ; OFF: Not beeps.

BT F/W UPDATE

Display the firmware version and update the firmware. For how to update the firmware, access our web site.

www.kenwood.com/cs/ce/bt/

MIC GAIN

-20 — 0 — 8: Adjust the sensitivity of the microphone for telephone call or adjusts the voice of the caller.

ECHO CANCEL

1 — 4 — 10: Sets the echo cancellation level.

(Colored text: Factory setting)

Contents