2.2 Preparation
How to read this manual
Operations explained mainly using buttons on the faceplate.
- [ ] indicates the buttons on the panel.
- XX indicates the selected items.
How to attach/detach the faceplate
- Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing.
- Keep the faceplate in its casing while detached. (for KDC-X797)
- The faceplate is a precision component of the unit and can be damaged by shocks or jolts.
- To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers.
Canceling the demonstration mode
The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
"CANCEL DEMO" X "PRESS" X "VOLUME KNOB"
- Press the volume knob.
"YES" is selected for the initial setting.
- Press the volume knob again.
"DEMO OFF" appears.
- If no operation is done for about 15 seconds or if you turn the volume knob to select "NO" in step 2, "DEMO MODE" appears and the display demonstration starts.
Adjusting the clock
- Press [SCRL DISP] repeatedly to select the clock.
- Press and hold [SCRL DISP] to enter clock adjustment mode.
- Turn the volume knob to adjust the hour, then press to enter minute adjustment.
- Turn the volume knob to adjust the minute, then press the knob.
- Press [E] / [F] to move between the hour and minute adjustment.
Changing the initial settings
Refer to <3.3 Changing the initial settings>
