INSTRUCTION MANUAL
KDC-DAB43U/ KDC-DAB4557U
CD-RECEIVER
INSTRUCTION MANUAL
CD-RECEIVER
What might seem to be a malfunction in your unit may just be the result of a slight operation error or a wiring error. Before calling for service, first check the following table for possible problems.
ö The key beep does not sound
Í The Preout jack is in use.
ò The key beep cannot be output from the Preout jack.
Í "KEY BEEP" is set to "ON" as mentioned in <3.3 Changing the initial settings>.
ö Sound cannot be heard.
Í Adjust the volume to the optimum level.
Í Check the cords and connections.
Í The connectors are dirty.
ò Clean the connectors. Refer to <Maintenance>.
ö The unit does not turn on.
ö Information shown on the display is incorrect.
Í The connectors are dirty.
ò Clean the connectors. Refer to <Maintenance>.
ö DAB reception is poor.
Í If an antenna included with KDC-DAB43U is used, set DAB ANT PWR "ON". See <DAB ANT PWR>.
ö Radio reception is poor.
Í The car antenna is not extended.
ò Pull the antenna out all the way.
ö The specified disc does not play, but another one plays instead.
Í The specified CD is quite dirty.
ò Clean the CD with reference to <Handling discs>.
Í The disc is severely scratched.
ò Try another disc instead.
ö Disc cannot be ejected.
Í The unit is malfunctioning for some reason.
ò Press and hold [G] to forcibly eject the disc. Be careful not to drop the disc when it is ejected. If this does not solve the problem, reset the unit. See <How to reset your unit>.
ö The sound skips when an Audio file is being played.
Í The media is scratched or dirty.
ò Clean the CD with reference to <Handling discs>.
Í The recording condition is bad.
ò Play the media again or use another media.
© 2012 JVC KENWOOD Corporation
