Controlling Audio

The [System Configuration] settings must match the configuration of the connected amplifiers and speakers. System Configuration settings

 

Using an amplifier with digital inputs (DMX1058XR/DAX1050XR/DAX800XR only)

When using an optical digital output, set the output sampling frequency in [Fiber Optic Output] to either 48 kHz or 96 kHz.

NOTE

  1. The bit count to 24-bit.
  2. If the digital output is set to 48 kHz or 96 kHz, the following Audio settings will be disabled.
  3. Speaker / X’over
  4. EQ / SW Level
  5. Position / DTA
  6. Fader / Balance
  7. Sound Effect
  8. Parametric Equalizer
  9. Audio Memory
  10. 3Way X’over Network
  11. EQ settings widget on the HOME screen
  12. Beep for User Interface Setup

 

Select the appropriate crossover network mode for the speaker system used (2-way or 3-way speaker system)

CAUTION

Connecting 3-way speakers with the 2-way mode selected can break the speakers.

 

Set [X’over Network] to either 2-way or 3-way. System Configuration settings

For the connection method, see 3-way speaker system setup. 3-way speaker system setup

NOTE

  1. When the 3-way speaker system is selected, the following functions are disabled.
  2. Fiber Optic Output
  3. Front focus of Listening Position / DTA
  4. Fader for Controlling General Audio
  5. Selection of the speakers to output sound from the smartphone/cell-phone of Bluetooth HF/Audio
  6. Beep for User Interface Setup

 

Select whether to use the built-in amplifier

Set the [Built-In Amplifier] to either ON or OFF. System Configuration settings Connection & AV Setup

Turning off the built-in amplifier improves the quality of the sound from Preout.