Installation procedure

1. To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of the battery.
2. Remove the vehicle parts for installing the unit and connecting wires to terminal.
3. Make the proper input and output wire connections for each unit.
4. Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle.
5. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle.
6. Connect the wiring harness connector to the unit.
7. Install the unit in your car.
8. Make sure that the unit is installed securely in place.
9. If the unit is unstable, it may malfunction.
8. Reinstall the vehicle parts.
9. Reconnect the ¤ terminal of the battery.
10. Perform the Initial Setup.
11. See Initial SETUP.